That’s it, your C40 TR Controller is ready to game! When the modules are in the desired configuration, replace the controller Faceplate and tighten the screws using the C40 TR Tool in the same star pattern. When swapping modules, ensure the red line located on the bottom of the module align with the red line located on the controller. The screws will remain attached to the Faceplate. We strongly recommend removing the screws in a star pattern (upper right, bottom left, bottom right, upper left). Using the C40 TR Tool, unscrew the 4 screws on the Faceplate of the C40 TR Controller. The Analog Stick Modules and the D-Pad Module are removable and swappable. That’s it! Your C40 TR Controller is ready to game. Your PC will automatically read and install drivers enabling the C40 TR Controller for use. Plug the USB-A end of the micro-USB cable into an available USB port on your PC. That’s it! Your C40 TR Controller is ready to go!Įnsure the C40 TR Controller Mode Switch is set to Wired. Follow the on-screen prompts to update the firmware. To check for firmware updates, click on the Configuration Wheel located at the top right corner of the software window. Plug the USB Wireless Transmitter into an available USB port on your PC. To update your USB Wireless Transmitter, first disconnect the C40 TR Controller from your PC or Mac. You will automatically be prompted to update the firmware of your controller after launching the C40 TR Configuration Software.Ĭlick on the Update Now button and follow the on-screen prompts to update the firmware on your controller. Run the ASTRO C40 TR Configuration Software. Plug the USB-A end of the micro-USB cable into an available USB port on your PC or Mac. Plug the micro end of the micro-USB cable into the C40 TR Controller. Please make sure that you are downloading the C40 TR Configuration Software and not ASTRO Command Center as ACC is not compatible with the C40 TR Controller.Įnsure the C40 TR Controller is in Wired Mode.

This guide will provide you with all of the information you will need to setup your C40 TR Controller with your PC or Mac.īefore use, this product may require a firmware update.ĭownload the ASTRO C40 TR Configuration Software from /software.

Anallog stick not working emulator mac